Shure WL50B Çok Yönlü Yaka Mikrofonu
Shure WL50B Çok Yönlü Yaka Mikrofonu en uygun fiyat ve taksit seçenekleriyle medumuzikmarket stoklarındadır
Shure's WL50B lavalier electret-condenser microphone is designed for use with T4AF equipped wireless body-pack transmitters. They are small, black, and visually unobtrusive. The WL50B is ideal for use in theater, film, broadcast, worship services, and any other time minimal microphone visibility is an important. The WL50B comes with a 5' (1.5m meter) cable terminated with a miniature four-pin connector, two foam windscreens, a dual tie clip, magnet mount, and mini mount. Sporting a full 20Hz - 20kHz frequency response, and with a 5.8mm diameter and an 11mm height, the WL50B is one powerful little microphone!
A prefect choice when you want your mic to be heard, not seen
Ready to work with any TA4F equipped body pack transmitter
A prefect choice when you want your mic to be heard, not seen
There are lots of situations that call for a microphone that can be heard but not seen. From theatre to the lecture hall, film to worship center, the WL50B hides nicely out of sight on your lapel, tie, or shirt collar to deliver your words to your audience without drawing attention to itself.
Because the WL50B uses the common TA4F connector and runs on standard +48V phantom power, it works well with most wireless bodypacks, including (but not limited to) Shure's PGX1, SLX1, and ULX1 wireless bodypack transmitters.
Features
Omnidirectional pickup pattern
20Hz - 20kHz frequency response
5.8mm diameter
11mm height
Includes two windscreens, a swiveling lapel clip, dual tie clip, magnet mount, and a mini mount
Specifıcations
Transducer Electret Condenser
Polar Pattern Omnidirectional
Frequency Response 20 Hz - 20 kHz
Dynamic Range (Typical) 103.0 dB
Signal-to-Noise Ratio 64 dB at 94 dB SPL
Maximum Input Sound Level 133 dB at 1% THD/1000 Ohm Load
Power Requirements +5v DC on Pin 2, Return on Pin 1 (Ground) Provided by Wireless Transmitters
Output Impedance Approximately: 136 Ohms, Actual (Rated at 150 Ohms)
Output Connectors TA4F Mini 4-Pin Connector Designed for Use with Shure Wireless Transmitters
Case Case Not Included
Pad None
Low Frequency Roll-Off None
Applications Wireless Audio for Videography, Broadcast, Live Performance (Stage), Lectures, etc.
Dimensions .48 x .23" (12 x 5.8mm) LxDiameter
Weight 7 oz. (21 g) with Cable and Connector